Digitus DN-16054-1 Guide d'installation télécharger pdf (Page 3)

CABLE DESCRIPTION

RJ45 network

cable

Connect it to the supplied RJ45 cable extender adapter for cable extension, and

prepare another RJ45 network cable with suitable length for your connection.

Reset wires Remove the insulating coating of these two wires, and twist them together to reset

default. This will reset all parameters, including the IP address to factory default

settings.

Note: Disconnect power before twisting these two wires together, and connect to

power again for reset default. When the reset is done, disconnect these two

wires.

Power wires Connect to AC power supply. For details, please refer to “2.2 Connect to power”

at page 5.

2. INSTALLATION & CONNECTION

2.1 Install the Camera

Note: The illustration below is for installation only, and the actual product may look

different from the illustration below.

Paste the supplied installation sticker to

the location where your camera will be

installed. Based on your installation

environment, drill a hole in the middle of

the sticker for the power & video cable

to put through later if necessary.

Slightly fasten the screws to (a) & (b) as

indicated, and make sure the screws are

not fastened to the end.

1 2 3 4 5 6 7 8 ... 19 20

Pas de commentaire

Digitus DN-16054-1 Guide d'installation Page 3