Digitus DN-16054-1 Guide d'installation télécharger pdf (Page 5)

2.2 Connect to power

Get a power cord and cut off its female connector side. Then, remove the insulating

coating to reveal positive, negative and ground wires.

Find the two wires labeled “AC+” (red) & “AC-” (black) on your camera, and remove

a small piece of their insulating coating to reveal the naked wires.

Twist the camera’s and power cord’s wires together according to the corresponding

electrodes (positive to positive, negative to negative, disregarding the ground wire).

Then, use the insulation tape to cover the connected wires.

Cut off the female connector and

remove the coating to reveal

positive, negative & ground wires.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Pas de commentaire

Digitus DN-16054-1 Guide d'installation Page 5